Effects Table - Blackstar ID:CORE STEREO 100 Owner's Manual

12. Effect Type
This changes the effect type and edits a parameter of the currently 'focused' effect
(modulation, delay, or reverb).
Each segment represents a different effect (four for each type of effect). An
LED shows which effect type is currently active. The distance travelled through
the 'segment' modifies an effect parameter. The Effects Table below shows the
modifiable parameters.
This setting is saved when you store a patch.
13. Effect Level
This modifies an effect parameter. For modulation and delay effects, turning the
Level control while holding down the Tap button (14) modifies the rate/time of the
effect.
The Effects Table below shows the modifiable parameters.
This setting is saved when you store a patch.
14. Tap
The Tap switch is used to set the rate/time of the current 'focused' effect. The time
between each press of the tap button defines the rate set.
Once set, the Tap LED will flash in time with the set rate of the currently 'focused'
effect.
The Effects Table below shows the modifiable parameters:

Effects Table

Effect Segment Parameter
MODULATION
Phaser Mix
Chorus/Flanger Morph
Octaver Octave down/up blend
Tremolo Frequency modulation depth
DELAY
Linear Feedback
Analogue Feedback
Tape Feedback
Multi Feedback
REVERB
Room Size
Hall Size
Spring Size
Plate Size
This setting is saved when you store a patch.
Level Parameter
Depth
Mix
Octaver/original guitar mix
Amplitude modulation depth
Delay level
Delay level
Delay level
Delay level
Reverb level
Reverb level
Reverb level
Reverb level
Tap Parameter
Speed
Speed
-
Speed
Time
Time
Time
Time
-
-
-
-
11