Supermicro SuperServer 2029TP-HC0R User Manual page 51

SuperServer 2029TP-HTR/HC1R/HC0R User's Manual
Installing Expansion Cards
1. Use the control panel to power down the computing node, and pull the node drawer out
of the chassis.
2. Open the PCI slot clip in the rear of the node drawer and remove the PCI slot shield.
3. If the riser card is not already installed, push it into the motherboard slot.
4. Slide the expansion card into the riser card slot and fit the expansion card shield into the
opening in the rear of the node drawer.
5. Close the PCI slot clip to secure the expansion card shield.
6. Secure the riser card screw.
7. Return the node drawer and power-up.
Note: Figure is for illustrative purposes only. Your system may or may not resemble this
picture.
Riser Card
Bracket
Riser Card
Figure 3-11. Installing the Expansion Card
51
Expander Card
PCI Slot
Shield