Coolant System - Grizzly G0763 Owner's Manual

Table Ball Bearing Strips
Type ......................T23964 or NLGI#2 Equivalent
Amount .............................................. As Needed
Lubrication Frequency .............................Monthly
To lubricate table ball bearing strips:
1. DISCONNECT MACHINE FROM POWER!
2. Remove table to expose ball bearing strips
(see Figure 47).
Ball Bearing Strips
Figure 47. Table ball bearing strips exposed.
3.
Use mineral spirits, stiff brush, and shop rags
to clean old grease and grim from strips,
saddle ways, and table ways.
4.
When dry, apply a medium coat of NLGI#2
grease to strips.
5.
Re-install table.
6.
Move table back and forth several times to
distribute lubrication.
-36-

Coolant System

Hazards
As some coolant ages, dangerous microbes can
proliferate and create a biological hazard. The risk
of exposure to this hazard can be greatly reduced
by replacing the old coolant on a regular basis, as
indicated in the maintenance schedule.
The important thing to keep in mind when working
with the coolant is to minimize exposure to your
skin, eyes, and respiratory system by wearing
the proper PPE (personal protective equipment),
such as splash-resistant safety glasses, long-
sleeve gloves, protective clothing, and a NIOSH
approved respirator.
BIOLOGICAL & POISON
Use the correct personal
protection equipment when
handling coolant. Follow
federal, state, and fluid
manufacturer requirements
for proper disposal.
A small amount of coolant is lost during normal
operation. Check the coolant tank regularly and fill
it if necessary. We recommend changing the cool-
ant every three months or sooner if it develops an
unpleasant odor. However, be sure to follow the
coolant manufacturer's instructions when check-
ing, adding, or changing coolant.
Running the coolant pump without ade-
quate coolant in the tank may permanently
damage the coolant pump, which will not be
covered by the warranty.
Model G0763 (Mfd. Since 6/15)
HAZARD!