Yaesu FTM-7250DR Advance Manual page 39

Menu Selection Details
41 SCNW MEM
Function: Set the memory scan frequency range. Set the frequency band range while
scanning in the memory mode.
Available Values: ALL / BAND
Default: ALL
ALL: All the memory channels are scanned without regard to the band of the registered
frequency of the memory channels.
BAND: Only memory channels with frequencies registered to the same band as the
channel on witch scan is started are scanned.
42 SCNW VFO
Function: Set the VFO scan frequency range. Sets VFO scanning action, when the
scanning reaches the end of a frequency band.
Available Values: ALL / BAND
Default: BAND
ALL: When scanning reaches the band edge, scanning continues into the next
frequency band.
BAND: When scanning reaches the band edge, scanning repeats within the same
frequency band.
43 SQL EXP
Function: Enables/Disables the split CTCSS/DCS coding.
Available Values: ON / OFF
Default: OFF
When this Set Mode Item is set to "ON", the following additional parameters are available
after the "PAGER" parameter when configuring Set Mode Item "44 SQL TYPE":
D CODE: DCS Encode only.
T DCS: Encodes a CTCSS tone and Decodes a DCS code.
D TONE: Encodes a DCS code and Decodes a CTCSS tone.
44 SQL TYPE
Function: Selects the Tone Encoder and/or Decoder mode.
Available Values: TONE / TSQL / DCS / RV TONE / PAGER / OFF
Default: OFF
TONE: CTCSS Encoder
TSQL: CTCSS Encoder/Decoder
DCS: Digital Coded Encoder/Decoder
RV TONE: Reverse CTCSS Decoder (Mutes receiver when matching tone is received)
PAGER: Enhanced Paging & Code Squelch
Note: See also Set Mode Item "39 SQL EXP" regarding additional selections
available during "Split Tone" operation.
38