Safety Precautions; Select Proper Location; Tilting - Red-D-Arc DC-600 Operator's Manual

A-2
Read entire Installation Section before installing
the DC-600.

SAFETY PRECAUTIONS

WARNING
ELECTRIC SHOCK CAN KILL.
•
Only qualified personnel should
install this machine.
• Turn the input power OFF at the
disconnect switch or fuse box before
working on the equipment.
• Do not touch electrically hot parts.
• Always connect the IDEALARC
DC-600 grounding terminal to a good
electrical earth ground.
• Set the DC-600 Power ON/OFF PUSH BUTTON to the OFF
position when connecting power cord to input power.
__________________
INSTALLATION

SELECT PROPER LOCATION

Place the welder where clean cooling air can freely
circulate in through the front louvers and out through
the rear louvers. Dirt, dust or any foreign material that
can be drawn into the welder should be kept at a mini-
mum. Failure to observe these precautions can result
in excessive operating temperatures and nuisance
shut-downs.

TILTING

The DC-600 must be placed on a stable, level surface
so it will not topple over.
DC-600
A-2