Trim Angle - TOHATSU MFS2.5B Owner's Manual

1. Air vent screw
ENON00208-0
Notes
 After stopping the engine, close the air
vent screw on the tank cap.
 Close the fuel cock. (Integral fuel tank)
ENOM00050-0

7. Trim angle

The trim angle of the outboard motor can
be adjusted to suit the transom angle of
the hull, and load conditions. Choose an
appropriate trim angle that will allow the
anti-ventilation plate to run parallel to the
water surface during operation.
ENOM00052-0
Proper trim angle
The position of the thrust rod is correct if
the hull is horizontal during operation.
1. Perpendicular to the water surface
ENOM00053-0
Improper trim angle (bow rises too
high)
Set the thrust rod lower if the bow of the
boat rises above horizontal.
1
90˚
ENOF00051-0
ENGINE OPERATION
ENOM00054-0
Improper trim angle (bow dips into the
water)
Set the thrust rod higher if the bow of the
boat is below horizontal.
2
1. Thrust rod
2. UP (Higher)
3. DOWN (Lower)
ENOW00043-0
WARNING
 Do not put hand or finger in between
outboard motor body and clamp bracket
31
ENOF00052-0
ENOF00053-0
1
3
ENOF00229-0