(5) Registered license will be active when after the power supply of the main device switch has been cut off once and put on again. Once the license starts properly,

press counter confirmation key then press device configuration and confirm that in the option column that the relevant kit has been indicated.

5.1.9.2 Method of confirming license option

iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i

Confirmation could be made whether the license option is active or not in the SOFT-ID PRM item by outputting the SPEC REPORT from the service mode.

Output method:

Select '# REPORT' from service mode.

Select '# REPORT OUTPUT'.

Select '# REPORT OUTPUT SPEC LIST' and press 'OK'.

Check the SOFT-ID RPM column from the SPEC REPORT output. License is active on the items which indicates 'ON/ON'.

5.1.9.3 Inactivity of the transmitted license

iR2022i / iR2025 / iR2030 / iR2018 / iR2022 / iR2018i

Inactivity of the transmitted license

Situation of using this service mode

This service mode is to be used exceptionally on the assumption that when malfunction occurs on the device (caused by device) and the license to be transferred to

the substitute device and to inactivate the license.

This operation is called ' Inactivity of the transmitted license'. Transmission could be selected to the same device and could be used to cease the function temporary.

But if the license is made inactive by mistake, it is necessary to call the dealer to reactivate.

Take utmost precaution when inactivating the license

To inactive the license, operation through the service mode has to be made and to prove the function is inactive; issue of the function inactive certificate key is

necessary.

This operation is valid to any of the each optional function and at the point of issuing the function inactive certificate key the function will be inactive and could

not be used.

New license key to install to the transmitted device will be issued when the information of function inactive certificate key, serial number of the transmission origin

device, serial number of new destination of transmitting device and the reason for transmitting is given to the dealer. Take a note of the new license key and after

the registration to the new transmitted device, inform the user that the new license key should be kept with care.

Operation procedures

(1) Go into the service mode and indicate the below mentioned service mode. (Key operation to go into the service mode is to be pressed one at a time. Orders are

*, 2, 8, *).

After going into the service mode, use the arrow on the both sides of the touch panel and press 'OK' if the decision is made.

(2) Indicate '#LMS'.

(3) Press 'OK' and indicate '#LMS INACTIVE'.

(4) Indicate 'BDL-IMAGE (CARPS 2 for Japanese market) or 'SEND'.

(5) Press 'OK'.

(6) Press '2' from the numeric keypad and press 'OK'.

1.Take a note of the license transmit number which will be indicated with 24 digits.

2.The indicated number is just for this operation and it would not be saved.

3.If the power is switched off, the indicated number will disappear and if the note of the number has not been taken, transmission of the license will be impossible.

4.Even pressing the reset key to clear the indication, there will be no recovery of the number.

Example of the transmitted license indication:

(7) Switch the power supply OFF/ON of the main machine.

#SEND

001

F-5-5

F-5-6

Press '2' from the numeric

keypad and press 'OK'.

Chapter 5

0017-8538

0017-8539