Canon iR2030 Portable Manual page 20

Chapter 3
Display
Detail Code
Code
E196 0001
0002
E197 0000
E261 0000
E716 0000
E719 0000
0002
E730 0000
E733 0000
E736 0000
E739 0000
8
Main Cause/Symptom
Image processor PCB failure
Error on writing and readout ROM of image processor PCB
(mainn ROM).
Image processor PCB failure
Error on writing and readout ROM of image processor PCB
(option ROM).
Printer engine communication error
Erroneous communication between the DC controller PCB and
image processor PCB was detected.
Zero-cross signal error
If failed to detect zero-cross signal cycle of the power supply
when initializing.
When the input of the zero-signal failed continuously for three
seconds while controlling the temperature adjustment.
Erroneous communication with optional cassette
Disconnection of the optional cassette was detected after
power-on, detection of normal connection to the optional
cassette, and start of communication.
Erroneous communication with card reader (serial communication)
- Disconnection from the card reader has been detected since
communication started after confirmation of normal connection
to the card reader (after power-on).
- A serial communication error has occurred. (The serial
communication error cannot be recovered.)
Erroneous communication with coin vendor (serial communication)
- Disconnection from the coin vendor has been detected since
communication started after confirmation of normal connection
to the coin vendor (after power-on).
- A serial communication error has occurred. (The serial
communication error cannot be recovered.)
Inside error of the image processor PCB (PDL system error)
The inside of the image processor PCB is faulty.
Erroneous communication between controller and printer
Cannot communicate with the printer at startup.
CCU communication error
The installed modem PCB is incompatible.
Erroneous communication between controller and network board
The installed network board is incompatible.
Countermeasure
- Putting the switch on/off of the power supply.
- Replace the image processor PCB.
- Putting the switch on/off of the power supply.
- Replace the image processor PCB.
- Check the connectors of the DC controller PCB and image
processor PCB.
- Replace the DC controller PCB for normal connection.
- Replace the image processor PCB.
- Replace the power supply PCB.
- Replace the DC controller PCB.
- Check the connectors of the optional cassette PCB and DC
controller PCB.
- Replace the optional cassette PCB for normal connection.
- Replace the DC controller PCB.
- Check the connectors of the card reader and image processor PCB.
- Replace the card reader for normal connection.
- Replace the image processor PCB.
- Check the connection between the image processor PCB and serial
PCB.
- Check the connectors of the serial PCB and coin vendor for normal
connection.
- Replace the serial PCB.
- Check the coin vendor.
- Replace the image processor PCB.
- Putting the switch on/off of the power supply.
- Replace the image processor PCB.
- Check the connectors of the DC controller PCB and image
processor PCB for normal connection.
- Check the power supply of the printer (Check whether initialization
is performed at startup).
- Replace the DC controller PCB or image processor PCB.
- Check the connectors of the image processor PCB and modem.
- Replace the modem PCB.
- Replace the image processor PCB.
- Check the connectors of the image processor PCB and LAN PCB
for normal connection.
- Replace the LAN PCB.
- Replace the image processor PCB.