Electrical Connection - Hoshizaki DCM-230FE Instruction Manual

2. ELECTRICAL CONNECTION

This ice dispenser requires an earth that meets the national and local electrical code
requirements. To prevent possible severe electrical shock to individuals or extensive
damage to equipment, install a proper earth wire to the ice dispenser. Remove the plug
from the mains socket before any maintenance, repairs or cleaning is undertaken.
• This ice dispenser must have a separate power supply or receptacle of proper capacity. See the
Nameplate.
• The main control box fuses are rated at 10A, 1A and 0.5A and should only be replaced by a qualified
service engineer.
• Usually an electrical permit and services of a licensed electrician are required.
• If the supply cord and the plug should need to be replaced, it should only be done by a qualified service
engineer.
For the U.K. and the Republic of Ireland only
• The wires in the mains lead are coloured in accordance with the following code:
As the colours of the wire in the mains lead of this appliance may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green-and-Yellow must be connected to the terminal in the plug which is
marked with the letter E or by the symbol
is coloured Blue must be connected to the terminal which is marked with the letter "N" or coloured
Black. The wire which is coloured Brown must be connected to the terminal which is marked with the
letter L or coloured Red.
• Should the socket outlets in the installation site not be suitable for the plug supplied with your product,
the plug must be removed (cut off if it is moulded on plug) and an appropriate plug fitted.
If the non-rewirable plug has been cut from the power supply cord, it must be disposed of. There
should be no attempt to reuse it. Inserting such a plug into a socket elsewhere presents a serious risk
of electrical shock.
• The non-rewirable plug must never be used without a fuse cover being fitted.
The correct replacement for the detachable fuse cover is identifiable from the manufacturer's reference
number stamped on the plug.
Supply of replacement fuse covers can be obtained from Hoshizaki Parts/Service Centres.
Fuses should be rated at 10A and approved to BS 1362.
A2FA10A9907
THIS APPLIANCE MUST BE EARTHED
Green & Yellow = Earth
Blue = Neutral
Brown = Live
WARNING
or coloured Green or Green-and-Yellow. The wire which
3
ENGLISH