Table of Contents
Advertisement
● For one load
Take out to the common terminal block and configure for parallel connection. The common
terminal block is used to connect all power supply lines in this case, eliminating the need to run
cables between power supply units. Variations in the output current of each power supply unit
can be better suppressed if not connecting on the power supply side.
+
+
+
+
-
-
-
-
Common terminal block
Figure 4.1.4 Connections for parallel operation (One load)
Max.: 5 units
4.1 Specification Details
Load
24 V
GND
4-4
Advertisement
Table of Contents
