6.9. High Voltage Connection
6.9.1. Preparing the high voltage connection
Cable-securing
adapter
WARNING :
Ensure that insulation is not
damaged. Any scratch or start of a cut on the
surface of the insulating material will result in
breakdown of the high voltage cable.
• Step 1: Strip back approximately 22.5 cm of
the purple insulation from high voltage
cable with a wire stripper. A "Stanley knife"
type cutting tool must not be used.
Next strip back approximately 19 cm of the
semi-conductive sheath (black sleeve)
and cut it with cutting pliers.
• Step 2: Insert seal and clamp into the nut.
• Step 3: Slide the nut assembly, split cone
and the cable-securing adapter onto the
cable. Then screw the nut onto the
adapter.
Index revision : C - November 2017
Supporting
Split
Nut
Clamp
cone
High voltage
End fitting
cable
36
Protective hose
Step 1
Step 2
Step 3
7030