Advertisement
ADDITIONAL COMPONENTS REQUIRED
*Electric Motor: 6S–1000/1400 Kv, 12S–500/700 Kv
maximum diameter 52mm, maximum height 56mm,
pinion shaft diameter 5 - 6mm
*Speed controller: 6S minimum 100A, 12S minimum 80A
*Batteries: 6S–5000/5500 mAh, 12S–2600/3300 mAh
*1 flybarless 3 axis control unit
*Radio power system, if not integrated with the ESC
*3 cyclic servos
*1 tail rotor servo
*6 channel radio control system on 2.4 GHz
Inside the box:
Inside The Box:
Box 1: Canopy, Bag 1-A, Bag 1-B, Bag 1-C and
Blade Holder.
Box2: Optional Combo Components
Box 3: Mechanical Parts in 3 trays:
Tray 1: Head parts
Tray 2: Main structure
Tray 3: Transmission parts
Box 4: Bags
Box 5: Blades, Tail Blades, Boom, Carbon Rod
TOOLS, LUBRICANTS, ADHESIVES
*Generic pliers
*Hexagonal driver, size 1.5, 2, 2.5, 3, 4 mm
*4mm T-Wrench
*5.5mm Socket wrench (for M3 nuts)
*7mm Hex fork wrench (for M4 nuts)
*Medium threadlocker (eg. Loctite 243)
*Strong retaining compound (eg. Loctite 648)
*Spray lubricant (eg. Try-Flow Oil)
*Synthetic grease (eg. Tri-Flow Synthetic Grease)
*Grease (eg. Vaseline Grease)
*Cyanoacrylate adhesive
*Pitch Gauge (for set-up)
*Soldering equipment (for motor wiring)
The assembly process is described in the following chapters.
Each chapter provides you with the box, bag and/or foam tray
numbers you will need for that chapter. The information is
printed in a red box in the upper right hand corner of the page
at the beginning of every chapter.
Chapter 3, In The Box
Page 3
Advertisement
