D Printer Media - Allen-Bradley FAST TRACK Manual

•
The IC chip in these ink cartridges contains a large amount of cartridge-specific information, for
example, the level of ink remaining in the cartridge, to ensure the trouble-free replacement of
the old ink cartridge with a new one. However, ink is used every time a new ink cartridge is
inserted, because the FAST TRACK
•
If you wish to remove an ink cartridge for use at a later date, then you must protect the ink
supply outlet from dust and becoming soiled. Please store the ink cartridge in the same
surroundings as the FAST TRACK
outlet, which means that neither a cover nor a lid is required. However, you should always
handle ink cartridges with care, failure to do so could result in a leakage. Never touch the ink
supply outlet of the ink cartridge or the area around it.
•
Applicable in Germany: ensure when connecting the FAST TRACK
supply that the building installation is fused with an appropriate back-up fuse.
This device is subject to special conditions regarding its connection to the mains supply.
The system impedance at the connecting point of the public supply system must not exceed
(0.14 + i 0.09) Ohm. In all other cases, consult the power supply company before connecting the
device to the public supply system. Please uninstall or deactivate the status monitor if you are
connecting the FAST TRACK
C. Suitable location for the FAST TRACK
•
Place the FAST TRACK
The FAST TRACK
•
Ensure there is sufficient space to allow the Marker Cards to be ejected without hindrance from
the FAST TRACK
•
Avoid installing the FAST TRACK
temperature and humidity. Ensure that the FAST TRACK
sunlight, strong light or excessive heat.
•
Avoid locations subject to impact shocks and vibrations.
•
Do not install the device in dust-filled surroundings.
•
When installing, ensure that the FAST TRACK
•
Install the FAST TRACK
removed at all times.
D. Printer media
Use the FAST TRACK
TM
TM
Printer to a network.
TM
TM
Printer on a flat, stable surface larger than base area of the printer.
TM
Printer will not operate properly if it is on a tilt or at an angle.
TM
Printer.
TM
TM
Printer near a socket outlet, ensuring that the plug can be easily
TM
Printer only for printing Allen Bradley 1492-M...Marker Cards.
TM
Printer always carries out a reliability check.
Printer. Please note that a valve is fitted in the ink supply
Printer
Printer in any location where it is subject to rapid changes in
TM
TM
Printer is sufficiently ventilated on all sides.
TM
Printer to the power
Printer is not exposed to direct
5