Error Indication - Allen-Bradley FAST TRACK Manual

Caution:
•
Use only ink cartridges from Allen Bradley, Cat. No. 1492-PRTINKCART or 1492-PRTCLEAN
•
Remove used ink cartridges only when you have a replacement available and have prepared
the installation. Otherwise, any ink remaining in the nozzles could dry out.
•
Do not refill the ink cartridges. The FAST TRACK
in the cartridges with the help of the IC chip on side of the ink cartridge. The IC chip does not
recalculate the remaining level of ink when the cartridge is refilled, so that the available amount
of ink does not change.
Note:
You cannot continue with a print job if the ink cartridge is empty. You must replace the empty cartridge
first, before you can proceed with printing.
•
Ink is not only expended when printing Marker Cards. It is also used during print head cleaning,
when replacing the ink cartridges as well as during the self-cleaning cycle that takes place every
time the FAST TRACK

7. Error indication

Error message:
LED Indicators:
Remedy:
Error message:
LED indicator:
Remedy:
For more information, please refer to the Short Installation Manual.
If it is not possible to acknowledge a fault in the FAST TRACK
Status Monitor, pressing the reset button once will reset the printer.
Strip was transported through: If the operator first forgets to insert a Marker Card then inserts one when
TM
the FAST TRACK Printer is attempting to draw in a non-existent Marker Card, then it will transport the
Marker Card added later through the device without printing.
If you forget to insert a Marker Card, allow the FAST TRACK
message, add a Marker Card then acknowledge the error by pressing the maintenance button.
Error message:
Remedy:
TM
Printer is turned on.
LED indicator – Marker Card is not inserted correctly
The red LED lights up constantly and the green LED flashes.
Check if the strip has been correctly inserted or if an unknown print job is active
in the printer driver. Open the printer driver and delete the print job.
Paper jam
The red LED lights up constantly and the green LED flashes.
Settings in the printer driver: The FAST TRACK
correct. (Please see Section 4.1 for Settings)
Ink cartridge not recognised
Remove the adhesive labels and check if the cartridge was correctly inserted.
Re-insert the ink cartridge.
TM
Printer calculates the remaining level of ink
TM
Printer settings are not
TM
Printer by pressing button 3 or via the
TM
Printer to continue and issue an error
19