Allen-Bradley FAST TRACK Manual page 16

5. Printer Operating Panel
Operating panel
Button 1: Setting the fusing unit power ratio and temperature
This button allows you to adjust the power ratio of the fusing unit to suit different types of markers.
The device is set to 100% power when turned on; the LED for 100% lights up
Press once to set the device to 80% power; the LED for 80% lights up
Press twice to set the device to 60% power; the LED for 60% lights up
Press three times to turn off the fusing unit, for example to adjust the print head.
Press four times to reset the device to 100% power; LED for 100% lights up
Button 2: Replacing the ink cartridge
Manual control of replacing the ink cartridge. Moves the print head into position for replacing the ink
cartridge when empty, and starts the ink carriage change sequence.
Button 3: Maintenance button
Manually cleaning the ink cartridge.
Press and release this button again within 3 seconds to draw paper into or eject paper out of the device.
Press this button to continue the printing process following the error message "Paper Out", once paper
has been loaded.
Press this button continuously for 3 seconds, when the error indicator LED is not lit up, to initiate the
print head cleaning process.
Press this button to move the print head to the replacement position when the ink cartridge is empty.
Button 4: Reset button
TM
For manually resetting the FAST TRACK Printer following a fault. If it is not possible to acknowledge a
TM
fault in the FAST TRACK Printer by pressing button 3 or via the status monitor, pressing the reset
button once will reset the printer.
Button 5: On/Off button
Press to turn the printer on or off.
When the printer is on, press this button twice to delete print jobs.
LED 1: Error message (red LED)
There is a fault. The red LED lights up when there is no Marker card is in the printer. Place a Marker
card into the feeder and press the maintenance button to proceed with the printing process.
16