Replacing Or Installing Ink Cartridges - Allen-Bradley FAST TRACK Manual

6. Replacing or installing ink cartridges

Ink cartridges are sealed units. Under normal circumstances, ink will not leak out of an ink cartridge.
If you get ink on your hands, wash them thoroughly with soap and water. If you get ink in your
eyes, rinse immediately with plenty of water.
Installing ink cartridges
1. Press the Replace ink cartridge button.
2. The print head will move to the middle position. Never move the print head manually.
3. Press back the retaining clip of the ink cartridge to be replaced and lift the clamp upwards.
4. Remove the label with the inscription "Entfernen / Remove".
5. Insert the cartridge into the clamps (the label showing face-up and the chip facing towards the input rail).
6. Carefully press the clamp downwards until it snaps into place.
7. Close the cover of the printer.
8. Press the Replace ink cartridge button.
1492-PRTCLEAN
1492-PRTINKCART
The ink supply system is then activated; this process can take approximately 1 to 2 minutes. The print
head moves to its home position (far right-hand side), and the operation indicator LED lights up
continuously.
Never turn the printer off when the operation indicator LED is flashing!
When replacing an ink cartridge, always open both ink cartridge lids.
18