Manual Raise/Lower Switch - Toro ProCore 648 Service Manual

Manual Raise/Lower Switch

The manual raise/lower switch is located on the handle
control panel (Fig. 16). This rocker switch is one of the
components in the "OK to lower" circuit which is one of
the aerator control module inputs. See OK to Lower Cir-
cuit in the Circuit Operation section of this chapter for
additional raise/lower switch information.
The switch terminals are marked as shown in Figure 17.
The circuitry of the raise/lower switch is shown in the
chart below. With the use of a multimeter (ohms setting),
the switch functions may be tested to determine whether
continuity exists between the various terminals for each
switch position. Verify continuity between switch termi-
nals.
SWITCH
POSITION CIRCUITS
RAISE
MIDDLE/
AERATE
LOWER
(MOMENTARY)
Electrical System
NORMAL OTHER
CIRCUITS
NONE NONE
2 + 3 NONE
2 + 3 5 + 6
1. Manual raise/lower switch
Page 5 – 16
1
Figure 16
3
6
2
5
UP
Figure 17
ProCore 648