Traction Control Cable - Toro ProCore 648 Service Manual

Traction Control Cable

Removal
1. Remove traction control cable from hydraulic pump
control (Fig. 10) and traction lever on handle and (Fig.
11).
2. Remove traction control cable from machine noting
routing of cable to aid in correct installation.
3. Disassemble traction control cable using Figure 9 as
a guide.
Installation
1. Assemble traction control cable using Figure 9 as a
guide. Tighten lock nuts (item 6) so that compression
spring (item 4) has a length from 6.750" to 6.880" (17.2
to 17.4 cm).
2. Route traction control cable from traction lever on
handle to pump control noting original routing.
3. After assembly, make sure that steering components
do not contact traction cable.
4. Check and adjust traction drive for neutral (see Op-
erator's Manual).
Chassis
7
2
6
5
1. Traction control cable
2. Jam nut
3. Spring retainer
4. Compression spring
3
1. Pump control
2. Traction control cable
1. Traction lever
Rev. B
Page 6 – 12
8
4
3
2
Figure 9
5. Override rod
6. Lock nut
7. Ball joint (traction lever)
8. Ball joint (pump lever)
1
Figure 10
3. Cable ball joint
1
Figure 11
2. Cable ball joint
2
1
1
2
2
ProCore 648