This section provides detailed information on how to remove or install the components from your computer.
Recommended tools
The procedures in this document require the following tools:
•
Phillips #0 screwdriver
•
Phillips #1 screwdriver
•
Plastic scribe
microSD card
Removing microSD card
1
Follow the procedure in
Before working inside your
2
Press in on the microSD card to release it from the computer.
3
Remove the microSD card from the computer.
Installing microSD card
1
Slide the SD card into its slot until it clicks into place.
2
Install the
microSD
card.
3
Follow the procedure in
After working inside your
Base cover
Removing base cover
1
Follow the procedure in
Before working inside your
2
Remove the
microSD
card.
3
To remove the base cover:
a
Remove the mylar cap [1].
NOTE:
philips driver and puncture the mylar cover. Once the mylar caps are removed it cannot replaced, and the
screws will be exposed from that point forward.
b Loosen the M2.5x7 captive screws that secure the base cover to the computer [2] .
8
Removing and installing components
Removing and installing components
computer.
computer.
computer.
The screw cover on the base cover is made up of a mylar sticker. To remove this screw, use a regular
2