Before First Use; Daily Use - Electrolux EDE1072PDW User Manual

12 www.electrolux.com

9. BEFORE FIRST USE

Before you use the appliance for the first
time:
• Clean the tumble dryer drum with a
moist cloth.

10. DAILY USE

10.1 Start a programme without
delay start
1. Prepare the laundry and load the
appliance.
CAUTION!
Make sure that when
you close the door, the
laundry does not catch
between the appliance
door and the rubber
seal.
2. Set the correct programme and
options for the type of load.
3. Press the Start/Pause touchpad.
The programme starts.
10.2 Starting the programme
with delay start
1. Set the correct programme and
options for the type of load.
2. Press the delay start button again
and again as necessary.
You can delay the start
of a programme by 3, 6
or 9 hours.
3. Press the Start/Pause button.
The LEDs (9H, 6H, 3H) change on each
3 hours.
10.3 Change a programme
1. Turn the Programme knob to
2. Set the programme.
10.4 At the end of the
programme
When the programme is completed:
• An intermittent acoustic signal
operates.
• Start a short programme (e.g. 30
minutes) with moist laundry.
• The indicators End/Anticrease (End/
Anticrease) ,
• The Start/Pause indicator is on.
The appliance continues to operate with
the crease guard phase for
approximately other 30 minutes.
The crease guard phase removes
creases from your laundry.
You can remove the laundry before the
crease guard phase is completed. We
recommend, for better results, that you
remove the laundry when the phase is
almost completed or completed.
When the crease guard phase is
completed:
• The indicators End/Anticrease End/
Anticrease ,
• Start/Pause indicator goes off.
1. Turn the Programme knob to
2. Open the appliance door.
3. Remove the laundry.
4. Close the appliance door.
Always clean the filter and
empty the water container
when a programme is
completed.
10.5 Stand-by function
To decrease the energy consumption,
this function automatically deactivates
OFF
the appliance:
• After 5 minutes if you do not start the
programme.
• After 5 minutes from the end of the
programme.
10.6 Indicator lights
These lights indicate the following
functions:
comes on.
Filter comes on.
OFF