Harken LokHead 500 User Manual page 19

WARNING!
Failure to use correct number and type of mounting fasteners or failure to ensure correct mounting
surface strength can result in winch pulling off suddenly and unexpectedly during high loads,
possibly resulting in severe injury or death.
Fixing with M12 bolts
Only for lifting loads:
- It is possible to fix the plate using ratchet strap,
connectors, anchor devices�
- It is the installer's responsibility to carry out all
structural tests needed to ensure that the mounting
surface can withstand the load�
Ensure the plate is securely attached to the mounting surface,
so that it can operate under load without significant movement�
The winch plate must be installed so that the line can be led
through the pigtail to the winch drum, with no more than 30°
of line deflection in any plane� The installation should use
pulley deflectors if necessary to ensure a fair lead to the
winch� The pigtail should not take any angle load�
The winch plate must be installed in a position to allow sufficient working space around unit, so not to impede operation of
handles�
Winch plate must be installed in a position to ensure visibility of the lift trajectory by operator at all times�
WARNING!
Incorrect installation of winch plate may cause severe injury or death. Consult equipment supplier
if in doubt about correct position of winch plate.
04-04-16
to the load
ENGLISH
Fixing with Ratchet Strap
Only for lifitng loads
to the anchorage point
30°
max. deflection
30°
max. deflection
Winch LokHead 500
to the load
19