Table of Contents
Advertisement
Winch LokHead 500
Install the handle socket as shown:
4� Position the handle socket on the shaft�
Final Installation
1� Carry out Installation Procedure, then install winch on a flat surface in selected position�
2� Position base of winch in selected area and mark holes or use drilling template�
Drilling template is available on Harken
verify that size of template and hole position/sizes are correct� See reduced-size template�
NOTE!
When downloading winch templates make sure you have correct size paper and that printer will
output at 100%. Before drilling holes verify that template is correct in every detail. Harken cannot
be responsible for incorrectly drilled holes because of a faulty template.
3� Remove winch and drill five (5) 6�2 mm diameter clearance holes� If drilling and tapping consult industry standards for
drill/tap size� Important: Do not countersink bolts�
4� Bolt base of winch to support plate� Use bolts that are the correct length for thickness and type of support plate� Consult
equipment supplier if in doubt� Use five (5) M6 Hex Head (HH) bolts, washers, and nuts�
NOTE!
1/4" Hex Head bolts do not fit in the holes and cannot be used to mount winch.
5� To obtain correct Maximum Working Load (MWL) all five bolts, nuts, and washers must be securely tightened�
WARNING!
Failure to use correct number and length of mounting fasteners and/or failure to tighten them
correctly can result in winch pulling off suddenly and unexpectedly during high loads which may
cause load to drop, possibly resulting in severe injury or death.
16
5� Tighten the handle socket screw.
website, www�harken�com� Download, print and compare template to winch to
®
ENGLISH
04-04-16
Advertisement
Table of Contents
