Swann STCL407WUK Service Information page 32

Indesit Company
K. Pump & Float Switch
1. Depress the 2 pump cover locating tabs and pull the cover clear (Photos 1 and 2).
Photo 1
2. Access can now be gained
to the pump and float
switch.
3. To remove the pump float
switch assembly, release
the 2 clips either side of the
assembly and lift clear
(Photo 3).
L. Heating Assembly, Thermostats & Thermistor
1. Remove the right hand side panel.
2. Disconnect the wiring to the heater multi-pin connector.
3. Remove the 8 screws securing the heater unit to the rear panel.
4. Remove the 2 screws securing the heater to the rear cover.
NOTE 1: If replacing the thermostats both the cycling and one-shot
thermostat MUST be replaced should either fail.
NOTE 2: A cable tie must be used to secure the 3 way plug into
the heater connector - refer to photo.
NOTE 3: When refitting the heater cover, ensure the heater wiring
is not trapped between the inner and outer rear panels.
NOTE 4: 2 different screws are used to fit the heater cover.
The longer screws are to secure the heater cover to the base assembly.
Service Manual UK
Photo 2
Photo 3
Shown with
cover
removed
32 of 34
Released Clips
English
Cable Tie