Swann STCL407WUK Service Information page 31

Indesit Company
H. Front Bearing Pads / Support Wheels
Note: Either may be fitted - depending on production variations.
Ha Bearing Support Pads
1. Remove the drum as in (O).
2. Unclip the bearing pads which are located
on the front air duct.
Hb Drum Support Wheels
1. Remove the Drum (O).
2. Unscrew the Bearing Support Wheel fixing bolt.
Note:
When first started, it is normal for the drum to make
a noise for approximately 2 minutes, while the drum
support wheels centralise to the load conditions.
I. Door Switch
1. Remove the top cover as in (A).
2. Remove the console as in (C).
3. Depress the locking tab securing the switch to the front panel and remove the switch.
J. Rear Bearing (Tear Drop shaped)
1. Remove the rear bearing cover.
2. Remove the drive pin and collar.
3. Remove the tear drop bearing fixing screw.
4. Slide the bearing off the drum shaft.
Service Manual UK
Support
wheel
fixing bolt
31 of 34
Bearing Support Pads
Teardrop Bearing
fixing Screw
English