Dryer Overview - Swann STCL407WUK Service Information

Indesit Company

DRYER OVERVIEW

Introduction of Simplified Electronics
These Models are fitted with a new Electronic Module, which is fixed to a plastic carrier, located behind
the Console.
This Module replaces the Control Module (previously located in the Base), the Display Module +
Control Interface (previously located behind the Dashboard) and the Module to Display interface
harness, fitted to 2013 Production Tumble Dryers.
It is NOT interchangeable with earlier products which use 2 modules.
The module is covered with a white plastic water shield which must always be fitted correctly and
retained with its fixing clip.
Programming Connector
The module is programmed using Memwriter and a Hardware
Key or with a SmartCard Reader and Card, connected using a
Low End Adaptor.
(See pages 27 & 28 - Contol Board Programming)
These models have an Auto Test Cycle. See pages 7 & 8.
Fault Codes
These Models do NOT display a fault code if the dryer is in a
Fault Condition. See page 6.
Service Manual UK
17 of 34
Plastic Water
Shield
(if fitted)
Low End
Adaptor
Connection
point
Control
Module
Fluff
Barrier
Drum
Low End Adaptor connector
English