Swann STCL407WUK Service Information page 30

Indesit Company
D. Interface and Control Module Assembly
1. Remove the top cover as in (A).
2. Remove the console as in (C).
3. Remove the screws securing the Module to
the Console
4. Remove the programme knob by
compressing the tabs - see photo.
E. Belt
1. Remove the side panels as in (B).
2. Remove the cooling impeller cover using a small blade screwdriver to lift the cover locking tabs.
3. Remove the cooling impeller.
4. Remove the rear bearing as in (J).
5. Remove the heater unit as in (L).
6. Remove the recirculating impeller.
7. Remove the 3 hex head screws behind the recirculating impeller securing the motor to rear of the
base moulding. This will release tension on the belt.
8. Rotate the motor towards the centre of the dryer to disengage the belt from the jockey pulley.
9. Remove the 2 screws securing the rear panel to the side strut.
10. Remove the 2 screws securing the water container housing to the rear panel.
11. Remove the hose spigot from the container housing by rotating 90°.
12. Pull the rear panel backward to disengage the drum shaft from the drum rear panel and slide the
belt back to remove from the drum.
13. Replace in reverse order. When refitting the belt first position the belt over the jockey wheel, refit
as in (N).
F. Front Panel, Door Seal & Front Thermistor
1. Remove the top cover as in (A).
2. Remove the console as in (C).
3. Remove the plinth.
4. Remove the 2 screws securing the front panel to the side strut.
5. Remove the 6 screws securing the front panel to the air duct.
6. Remove the 3 screws located behind the plinth securing the front panel to the base.
7. The front panel can now removed leaving the air duct in position.
G. Air Duct
1. Remove the front panel as in F).
2. Remove the belt as in (E).
3. Lift the air duct upwards to remove from the base.
Service Manual UK
Compress programme knob retaining tabs
30 of 34
English