Swann STCL407WUK Service Information page 28

Indesit Company
Connection to the Module
The Smartcard Reader or Hardware Key (shown below) MUST only be connected to the module using
a Low End Adaptor - See method below. The Low End Adaptor edge connector plug connects to CN1
on the Module. The plastic Water Shield must be secured correctly after programming.
Plastic Water Shield
Connection CN1
Hardware Key
and USB cable
or Smartcard
Reader
PROGRAMMING (Using Smartcard Reader / Card)
If the Module has been replaced during a repair the board will require programming using the following
method. A module which is not programmed will not function.
1. Do NOT connect the dryer to electrical supply at this point.
2. Insert the pre-programmed card into the Card reader. Care must be taken at this point to ensure the
card is inserted correctly with the Chip on the card facing the PCB of the Reader.
3. Insert the Reader and Card into module connection port located at the front of the dryer - see photo.
4. Connect the dryer to the Electrical
Observe the electronic component side of the SmartCard Reader.
The LEDs on the Smart Card Reader will light in this sequence:
a. Red ON: Good Communication between Smart Card Reader & Card. See also Note 1 below.
b. Red OFF; Green
c. At end,
Green ON = Download OK, module programmed,
below.
6. Disconnect the appliance from the electricity supply.
7. Remove the Smart Card Reader.
8. Connect the appliance to the Electrical supply.
Note 1.
a If the Red LED is flashing SLOWLY, a card is inserted but either the card is blank (previously
used), is incorrectly inserted or there is a poor connection between the card and card reader.
b If the Red LED is flashing RAPIDLY, a card is NOT inserted or not inserted fully.
Note 2. SmartCard Re-Use
The Smart Card cannot be used again. It is erased after a successful download of the settings file onto
the module.
Service Manual UK
supply;
Blinking: Download taking place.
Low End Adaptor
Red ON = Download
28 of 34
NOT OK -see Note 1.
English