Setting Alarms And Timers - Raymarine GPS Plotter Owner's Handbook Manual

3-46

Setting Alarms and Timers

➤
To set up an alarm or timer:
1. Press the ALARMS key. The Alarms Set Up list is displayed, showing
2. Use the trackpad up/down to navigate through the list. As each line is
3. Use the up/down arrow soft keys to change the alarm value. For
4. Alarm distances are set in the range 0.01nm to 9.99nm, in steps of
5. If required, press the ALARM OFF ON soft key to toggle the alarm on or
Note: All alarms and timers can be switched on and off, except for the Ar-
rival Alarm which is always on.
6. Press ENTER to save the changes and clear the menu.
the current settings as shown in Figure 3-46.
ALARMS SET UP
Figure 3-46: Alarms Set Up Menu
highlighted, the soft keys are updated to show the current settings and
controls, as shown in Figure 3-46.
example, in the case of the arrival alarm, adjust the radius around the
waypoint at which you require the arrival alarm to be triggered.
0.01nm. The countdown timer is set in hours and minutes. The alarm
clock is set in hours and minutes.
off. If you turn an alarm off, its value is retained and will be used when
you turn the alarm on again.
Raynav 300 GPS Plotter
D4898_2