Editing Waypoint Details - Raymarine GPS Plotter Owner's Handbook Manual

3-18
2. To remove the Waypoint List and return to the default soft key dis-
➤
To display the Waypoint Data Box:
1. Move the cursor over the waypoint.
➤
To remove the Waypoint Data Box and soft keys either:
1. Move the cursor away from the waypoint, or...
2. Press CLEAR .

Editing Waypoint Details

You can change the name, symbol and position of any waypoint (except
the target waypoint).
➤
To edit a waypoint:
1. Select the waypoint, using the cursor or the Waypoint List, as
2. Press the EDIT WAYPOINT soft key. The Edit Waypoint soft keys are
Note: The ERASE WPT soft key is only available via the Waypoint List.
3. To edit the symbol, press the SYMBOL soft key.
4. To edit the waypoint name, press the NAME soft key.
play, press CLEAR twice.
• The Waypoint Data Box is displayed which indicates waypoint
number/name, bearing and range (or lat/lon if selected in the sys-
tem set up menu, see System Set Up Parameters on page 4-2).
• Whilst the cursor is over the waypoint, the waypoint soft keys are
displayed, see Figure 3-23.
described in Selecting a Waypoint on page 3-17. The waypoint soft
keys are displayed.
displayed:
Figure 3-24: Edit Waypoint Soft Keys
Use the soft keys, shown in Figure 3-25, to highlight the required
symbol, then press ENTER to confirm the selection.
Press CLEAR to return to the default soft keys.
Figure 3-25: Waypoint Symbol Selection
Raynav 300 GPS Plotter
D4908-1
D4909_1