Setting Alarms And Timers - Raymarine 530 Owner's Handbook Manual

Chapter 4: Further Chart Operations

Setting Alarms and Timers

➤ To set up an alarm or timer:
1. Press the ALARMS key. The Alarms Set Up menu is displayed, showing
ALARMS
the current settings (see Figure 4-2).
2. Use the trackpad to move the selection bar up or down the options. As each
line is highlighted, the soft key labels are updated to show the current set-
tings and controls.
Figure 4-2:
3. Use the up or down soft keys to change the alarm setting. For example, for
the arrival alarm you can adjust the radius from the waypoint at which the
arrival alarm will be triggered.
The arrival, off track and anchor alarm distances can be set in the range
0.01 to 9.99 nm, in steps of 0.01nm.
The grounding alarm depth can be set from 1 to 20m in 1m steps and can be
specified to cover a sector at a range from 0 to 1nm, in 0.1nm steps.
The timer is set in hours, minutes and seconds, and the alarm clock in hours
and minutes.
4. If required, press the ALARM OFF ON soft key to toggle the alarm on or off.
If you turn an alarm off, its value is retained and will be used when you turn
the alarm on again.
Note: You can turn all the alarms and timers on and off, except for the Arrival
Alarm which is always on.
5. Press ENTER to save the changes and clear the list.
ALARMS SET UP
Alarms Set Up List
4-5
D4265-4