Raymarine GPS Plotter Owner's Handbook Manual page 96

Chapter 5: Installation
Note: Failure to remove the plastic tabs from within the cable channel
could result in cable damage.
3. Screw the supplied brass studs (2) into the underside of the GPS
4. Affix the supplied gasket (3) to the mounting surface ensuring that the
5. Carefully position the GPS Antenna, passing the studs through the
2
4
Top view
mounting surface, remove the two plastic tabs (1) obstructing the
cable channel.
Antenna.
holes match and pass the cable through the centre hole or the cable
exit channel.
holes in the mounting surface and secure to the mounting surface
using the thumb nuts provided (4).
Figure 5-2: Surface Mounting Arrangement
3
2
4
Underside view
5-5
1
3
D4725_1