Suppression Ferrites; Connections To Other Equipment; Unpacking And Inspecting The Components - Raymarine Chartplotter Owner's Handbook Manual

5-2
• If a suppression ferrite is attached to a cable, this ferrite should not be
removed. If the ferrite needs to be removed during installation it must be
reassembled in the same position.

Suppression ferrites

The following illustration shows typical cable suppression ferrites fitted to
Raytheon equipment. Always use the ferrites supplied by Raytheon.

Connections to other equipment

If your Raytheon equipment is to be connected to other equipment using a cable
not supplied by Raytheon, a suppression ferrite MUST always be fitted to the
cable close to the Raytheon unit.

5.2 Unpacking and inspecting the components

Unpack your RayChart 420 Chartplotter carefully. Retain the carton and
packing materials in the event that you need to return the unit for service.
Check that you have all the correct system components. These depend on your
system package:
Item Item Item Item Item
RC420 System RC420 System RC420 System
RC420 System RC420 System
comprising:
RC420 Chartplotter
RS112LP
RC420D System RC420D System RC420D System RC420D System RC420D System
comprising:
RC420 Chartplotter
RS114
RC420 Accessories: RC420 Accessories: RC420 Accessories: RC420 Accessories: RC420 Accessories:
Sun cover
Panel mounting kit
Trunnion mount kit
Power cable
GPS extension cable
Handbook
Quick Reference Card
RayChart 420/420D Chartplotter
Part No. Part No. Part No. Part No. Part No.
E32012
E32014
E32002
E32013
E32014
E32003
E35004
E35006
E35005
R38024
E35003
81162
86051
Supplied with Supplied with Supplied with Supplied with Supplied with
RC420
RC420
RC420D
RC420D
All
Optional
All
All
Optional
All
All