Raymarine Chartplotter Owner's Handbook Manual page 63

4-2
3. Use trackpad up/down to move the highlight up or down the list.
4. When the required parameter is highlighted, use trackpad left/right to step
through the settings.
5. When you have reset to the required values, press ENTER to implement
the change and return to the set up function bar.
6. Press CLEAR to clear the function bar and return to the chart display.
Note: You can return all the settings to their original factory settings, if
required, by performing a factory reset as described in Chapter 6.
The following table lists the System menus and their options, shows the factory
default settings and provides space for you to make a note of your new settings.
Each parameter is described in the following subsections.
Menu
BEARING MODE
KEY BEEP
DISTANCE UNITS
SPEED UNITS
DEPTH UNITS
VARIATION
Options
MAGnetic
TRUE
OFF/ON
NAUTICAL MILES (nm)
KILOMETRES (km)
STATUTE MILES (sm)
KNOTS
KILOMETRES PER HOUR (KPH)
MILES PER HOUR (MPH)
METRES
FEET
FATHOMS
30°W to 30°E (1° steps)
RayChart 420/420D Chartplotter
Factory New
Default Setting
TRUE
ON
NAUTICAL MILES
KNOTS
METRES
0.0E