Chapter 2: Getting Started & Adjusting The Display; Introduction; Conventions Used; Simulator - Raymarine 530 Owner's Handbook Manual

Chapter 2: Getting Started & Adjusting the Display
Chapter 2: Getting Started & Adjusting the

2.1 Introduction

This chapter provides information and instructions to get you started using
your display. It will help you to become familiar with the display and the
functions of the controls before you start using the unit. Chartplotter operating
details are given in Chapter 3 and Chapter 4.

Conventions Used

Throughout this handbook, the dedicated (labelled) keys are shown in bold
capitals; for example, MENU. The soft key functions, menu names and
options are shown in normal capitals; for example, SCREEN.
Operating procedures, which may consist of a single key-press or a sequence
of numbered steps, are indicated by a ➤ symbol in the margin.
When the procedure requires you to press a soft key, the soft key icon is shown
in the margin.

Simulator

The display unit includes a simulator function, that allows you to practice
operating your Chartplotter without data from the GPS system. You will need
to use the set up options to switch the display to simulator mode, as described
in Section 2.2. You can use it in either of two ways:
• Before the display unit has been installed on your vessel. In this case, you
only need to connect the display to a 12V or 24V DC power supply, con-
necting the red core from the power lead to positive (+) and the black core
to negative (-). See Chapter 6 for full details.
• After the display has been installed on your vessel, but while in the marina
or at anchor.
The following section, Section 2.2, includes instructions to view simulated
chart images.
Display
2-1