Chassis and Power Supplies
Installing the New Fan Tray
1
Align the new fan tray's captive screws with the threaded holes at the rear of the chassis. The fan tray
has an onboard power connector that plugs into a power connector socket on the chassis. In addition to
aligning the captive screws, be sure that this power connector is aligned with the power connector socket
on the chassis. Next, push the fan tray straight against the switch chassis.
Align the Captive Screws. Align the fan tray's
captive screws with the threaded holes in the
chassis. Push the fan tray back against the switch
chassis.
2
When the attachment flanges are flush against the chassis rear panel, tighten the captive screws.
OmniSwitch 9000E Series Hardware Users Guide
Aligning the Captive Screws
Tightening the Captive Screws
December 2008
Chassis Fan Tray
Tighten the Captive Screws. When
the attachment flanges are flush
against the chassis' rear panel,
tighten the captive screws.
page 2-35