Using A C-Map User Card; Saving Waypoints/Routes To A User Card - Raymarine Raychart 320 Owner's Handbook Manual

Chapter 3: Operation
3. To disable waypoint transfer, press the soft key STOP RECEIVING WAY-
Note: Where multiple waypoints have the same position, the last way-
point sent is the only one included in the Waypoint List.
Sending Waypoints to Other Equipment
➤
To send the Waypoint List on NMEA:
1. Display the Waypoint List as previously described, then press the
2. Press the SEND WPT LIST ON NMEA soft key; the soft key changes to

3.8 Using a C-Map User Card

Waypoints/Routes can be saved to or loaded from a C-Map User Card.
By this means, you can maintain a backup of your Waypoints and Routes,
transfer them to another vessel or extend the capacity of your unit by, for
example, keeping separate User Cards for different areas.

Saving Waypoints/Routes to a User Card

CAUTION:
Saving data to your User Card will overwrite all existing Waypoint
and Route data on the card.
➤
To save to a C-MAP User Card:
1. Press MARK ; the Waypoint soft keys are displayed, see Figure 3-44.
2. Insert a C-MAP User Card into the lower of the two cartridge slots.
3. Press the LOAD/SAVE USER CARD soft key; the User Card Menu is dis-
When waypoints are transmitted by other equipment they are added
to the Waypoint List on the display unit. Routes transmitted on
NMEA are appended to the Route List.
POINTS .
Alternatively, press CLEAR twice to close the Waypoint List.
WAYPOINT TRANSFER soft key.
STOP SENDING WAYPOINTS .
The Waypoint and Route Lists are transmitted from the display unit
to other equipment on NMEA.
Figure 3-44: Waypoint Soft Keys
played, together with it's associated soft keys, see Figure 3-45.
3-43