HP J3108A Installation Manual page 22

Hp advancestack switch 2000 fddi module

Table of Contents

Installing the Module in an Unused Slot

Generally, you only need to reboot the switch when it needs to recognize a

change in its hardware or software (console) configuration. Some circum-

stances under which you will need to reboot the switch are:

You add new modules or move modules to unused slots

You install a module in a slot that was previously occupied by a different

type of module (for example, installing an FDDI Module in a slot that was

previously used for an Ethernet module)

You change certain switch configuration parameters through the console

interface—in this case, the console provides messages indicating when

the switch must be rebooted for the configuration change to be activated

You do not need to reboot the switch if:

You are replacing an FDDI Module with the same type of module

You are moving a module to a slot that was previously occupied by the

same type of module (and no reboot has occurred since the previous

module was removed)

Table of Contents