Pin Light Port Extender Led Light Status And Start Up - QRS PNO3 User Manual

Pin Light Port Extender (PLx) LED Light Status and Start Up
Start Up
Operating System
Updating
Button Push
QRS Music Technologies, Inc.
QRS PNO
1 2
On Power Up—Lights cycle from right to left, each light blinks
Start Up Sequence
and cycle through each of its potential colors
1. Welcome to Pianomation
Voice Prompts 2. Operating Software Version Announced
(light #6 blinks 3. Announces Your System Is Ready
amber) 4. Announces if a Network Cable is Detected
5. IP Address Announced
Start Up Sequence
Lights will indicate their status (ref other pages —)
Complete
To hear status
Using the IR Remote pointed at the IR receiver (button on
again plus your
PLx): Select Shift (let go) then 3 (let go) or
systems serial
Hold PLx button down for 4 to 6 seconds
number
Green PNOscan optical record sensor strip is connected
Lights Gradually
All lights gradually light up based on update completion
Light Up from
percentage, all lit at completion, then reboot
Right to Left
1. Update
2. Please do not remove media or disturb power until update
Voice Prompts 3. Update in Progress (depends on size of update)
4. Update Complete
5. (system now reboots and you will lose connection)
6. Voice Prompts will follow the start up prompts
Button Push Starts and stops playback of the default playlist you have set
Button Push 4 to 6
Voice prompt information
sec
Button Push >16
Reboots piano first 3 lights turn amber and last light is red
sec
3
User Guide
3 4 5 6
is complete
6
Technical Support - 800-247-6557
www.qrsmusic.com