How To Configure Stand Alone Mode - QRS PNO3 User Manual

Using the
Both PNO
Stand Alone
Mode:
192.168.1.1
Netgear EX6100/AC750
PNO3 Stand Alone mode programming Steps
1. Flip the "Access Point/Extender" switch to the
"Access Point" position.
2. Plug the Extender into an outlet - wait for the
Power LED to turn green.
3. Use a paper clip to Press and Hold the "Factory
Reset" Button until power light flashes 3 times
(~10s)
4. The reset EX6100 will broadcast two SSID names;
EX6100_Netgear...2GEXT & 5GEXT (You may
want to turn the Wi-Fi OFF and then ON to refresh
the Wi-Fi list.)
5. Go to your device's Wi-Fi settings and Select
"EX6100_Netgear_2GEXT".
6. The Netgear "genie" should appear within one
minute. Or, go to your web browser - Safari or
Chrome & enter: www.mywifiext.net
7. A splash screen will appear stating device is set
to Access point, wait a moment and Configura-
tion Screen will appear
8. Select "No" on the configuration screen, then the
"Next" button, A pop up asking you to confirm
manual setup. Select OK
9. Authentication Required Pop Up will appear
Enter username: "admin" and "password" as the
Password then select "Log In" button.
QRS Music Technologies, Inc.
QRS PNO

How to Configure Stand Alone Mode

Net gear Extender EX6100 / AC750
3 AND the Piano's Wi-Fi device must be programmed to change modes.
NOT connected to the Internet.
PNO 3 is its own wireless network QRSPNO_2GEXT.
PNO 3 hands out IP addresses to your devices that are logged into it, Android, IOS...
PNO 3 delivers control for Android, Google Chrome or Safari web browsers.
Connect to PNO3 by entering 192.168.1.1 in the address bar of the web browser.
3
User Guide
[iPad
Technical Support - 800-247-6557
15
Example]
1
www.qrsmusic.com
3