How To Configure Network Mode - QRS PNO3 User Manual

Using the
Both PNO
Network
Mode:
IP address given out
by your home router
Netgear EX6100/AC750
PNO3 Stand Alone mode programming Steps
1. Flip the "Access Point/Extender" switch to the
"Extender" position.
2. Plug the Extender into an outlet - wait for the
Power LED to turn green.
3. Use a paper clip to Press and Hold the "Factory
Reset" Button until power light flashes 3 times
(~10s)
4. The reset EX6100 will broadcast two SSID names;
EX6100_Netgear...2GEXT & 5GEXT (You may
want to turn the Wi-Fi OFF and then ON to refresh
the Wi-Fi list.)
5. Go to your device's Wi-Fi settings and Select
"EX6100_Netgear_2GEXT".
6. The Netgear "genie" should appear within one
minute. Or, go to your web browser - Safari or
Chrome & enter: www.mywifiext.net
If requested, enter username = "admin" and pass-
word = "password and then Select "Log In".
Select your home Wi-Fi network from the 2G list.
Select "Continue".
Enter your home Wi-Fi password.
Select "Continue".
QRS Music Technologies, Inc.
QRS PNO

How to Configure Network Mode

Net gear Extender EX6100 / AC750
3 and the Piano's Wi-Fi device must be programmed to change modes.
NOT connected to the Internet.
PNO 3 is a node on your homes wireless network "homerouterssid_2GEXT."
PNO 3 hands receives its IP addresses from your router.
PNO 3 delivers control for Android, Google Chrome or Safari web browsers.
Connect to PNO3 by entering handed out IP address in the address bar of the
web browser.
3
User Guide
[iPad
Technical Support - 800-247-6557
17
Example]
1
www.qrsmusic.com
3