Brief How To - QRS PNO3 User Manual

NETGEAR EX6100 WI-FI EXTENDER (AC750)
The QRS PNOmation system ships with a NETGEAR EX6100 set to AP (as an Access Point). In order to play
all content available, receive auto updates, maximize ease of use and your investment, we recommend the
player system be set up as an extension of your homes network (network mode). To do this there are three
steps
1. Configure NETGEAR to extend your home network: Unplug the NETGEAR from the system, reset it and
configure it to extend your homes network as you would if you purchased the product separately. Ref
NETGEAR manual (steps we use are below)

Unplug the NETGEAR from the PNOmation system and flip the switch on the side to Extender

Plug into a wall outlet convenient to you and close to your router

You will need

Your network password (Case Sensitive)

Wi-Fi device

A paperclip to do a factory reset

Reset the NETGEAR using the paperclip (hold until power light flashes 3 times and restarts unit)

Log into Wi-Fi Network NETGEAR EX6100_2GExt once connected a network Geni should
appear

In the Geni—Select your homes network—continue

Enter your password– continue

Select Skip for the 5G setup

Select Private Network—continue

Select Continue on the next setup page

Select Ok on the pop up box - Wait for reboot— Verify connections with device LEDs -Done
1. Put your piano in Network mode - so it is set to receive an IP address from your router ("Shift" "B" on
your remote, or hold button 3 on the processor down for 4sec)
2. Plug the NETGEAR back to where it was prior to unplugging. Log into your homes network and use the
QRSFinder App from the App Store or Play Store - to open the system. Voice Prompts will also tell you
QRS Music Technologies, Inc.
3
QRS PNO User Guide

Brief How To

14
Technical Support - 800-247-6557
www.qrsmusic.com