QRS PNO3 User Manual page 16

How to Configure Stand Alone Mode (Cont.)
Using the
Both PNO
Stand Alone
Mode:
192.168.1.1
Netgear EX6100/AC750
PNO3 Stand Alone mode programming Steps Cont.
10. Go to "Setup / Wireless Setup
Enter the new "2GEXT & 5GEXT" SSID Names
QRSPNO_2GEXT & QRSPNO_5GEXT
Press the "Apply" Button, wait for reboot
11. Reconnect to QRSPNO_2GEXT & QRSPNO_5GEXT
12. Go to "Setup / Internet Setup"
13. Select "Use Static IP Address"
IP Address = 192.168.1.6
IP Subnet Mask = 255.255.255.0
Gateway IP Address = 192.168.1.1
14. Select "Use These DNS Servers
Primary DNS = 192.168.1.1
Secondary DNS = 10.0.0.250
Press the "Apply" button at the top of page and
wait the Net gear to update & reboot.
15. Reconnect to QRSPNO_2GEXT & log-in again.
Go to Setup / LAN Setup
Un-Check "Enable NAT" and press "Apply"
An Ethernet cable must now be attached to the
QRSPNO_2GEXT to wireless connect.
16. Using a QRS remote control:
Press the following buttons in sequence SHIFT A
17. Go to your device's Wi-Fi settings and Select "QRSPNO_2GEXT". (Do not use the QRSPNO_5GEXT).
Open your web browser and enter "192.168.1.1" in the address bar. This will take you to the QRS
PNO3 menu.
QRS Music Technologies, Inc.
QRS PNO
Net gear Extender EX6100 / AC750
3 AND the Piano's Wi-Fi device must be programmed to change modes.
NOT connected to the Internet.
PNO 3 is its own wireless network QRSPNO_2GEXT.
PNO 3 hands out IP addresses to your devices that are logged into it, Android, IOS...
PNO 3 delivers control for Android, Google Chrome or Safari web browsers.
Connect to PNO3 by entering 192.168.1.1 in the address bar of the web browser.
3
User Guide
[iPad
Technical Support - 800-247-6557
16
Example]
www.qrsmusic.com