Hopping Foot Height - Brother Dream Quilter 15 Service Manual

Hopping Foot Height

Tools Needed:
• 3mm Allen Wrench
1. Using the hand wheel in the back of your machine, rotate your machine until the nee-
dle bar is in the lowest position.
2. Attach your hopping foot to the press bar using a M3 socket head screw (don't tighten
during this step)
3. Using the hole in the needle plate, align the hopping foot so that is centered.
4. Place 8 sheets of paper under the foot and lower the hopping foot to the top of the
surface. You may need to use more or less sheets of paper if your project is particu-
larly thick or thin.
5. Tighten the bolt using the 2mm allen wrench
M3 Socket
Head Screw
Press Bar
Needle Plate
3mm Allen
Wrench
(Green
Handle)
6
Assembly
M3 Socket
Head Thumb
Screw
Hopping Foot