Handle Bars; Needle Plate - Brother Dream Quilter 15 Service Manual

Handle Bars

Tools Needed:
• 4mm Allen Wrench
• 3mm Allen Wrench
Display Clip - Top
Display Clip - Bottom
M5 x 10mm
SBHCS

Needle Plate

Tools Needed:
• Flat Head Screw Driver
Needle Plate Screw
Needle Plate
Front Handle Support Bar
M6 x 10mm SBHCS
M4 x 8mm SBHCS
1. Place your needle plate on your sewing
machine and rotate hand wheel to
ensure needle plate orientation so that
all screw holes are visible and needle
enters the middle of the needle plate
without contacting the needle plate at
any point
2. Attach your needle plate using 4 needle
plate screws, don't tighten the screws
during this step.
3. Rotate hand wheel until the needle is in
the lowest position move needle plate
till it is centered around needle and
tighten all 4 needle plate screws.
Needle
9 9
Assembly
M6 x 15mm SBHCS