Figure 11 Display Ver. And Sn; Figure 12 User Station Test; Figure 13 Channel Cim (Ukvm) Test; Figure 14 Stacking Support - Raritan II User Manual

Raritan computer paragon ii network device user manual

Hide thumbs

Table Of Contents

Table of Contents

1. Display Ver./SN (Firmware Version and Serial Number): Displays current version of firmware and

unit's serial number.

Firmware: 2C1

SN: CPB80347

2. Test User UST1 (User Station): Used by administrator to check if user stations (UST1s) are

functioning properly. Press the [ ] or [ ] button to change user port number. Display will read "OK",

"None", or "Failed. Press [ESC] to return to normal display."

If a "failed" condition is detected, make sure Category 5e UTP cable is installed properly and secured,

or try using another UST1 to see if UST1 under test has become defective.

Test User UST1

UST1: 3 OK

3. Test Channel UKVM (CIM UKVM): Used by administrator to check if CIM is functioning properly.

Press the [ ] or [ ] button to change channel number. Display will read "OK", "None", or "Failed."

Press [ESC] to return to normal display.

If a "failed" condition is detected, make sure Category 5e UTP cable is installed properly and secured,

or try using another CIM (UKVM) to see if CIM under test has become defective.

Test Chan. UKVM

UKVM: 60 OK

4. Test Stack Unit: Press the [ ] or [ ] button to select the corresponding Stacking Unit ID for any

connected units. If there are no Stacking Units connected, the LCD will display "None". If there are

Stacking Units connected, the LCD should read "Ok" for each unit. Press [ESC] to return to normal

display.

5. Stacking Support: Press the [ ] or [ ] button to set the Stacking Unit ID number (0 – 3 for a P2-

UMT832M or "0" or "1" for a P2-UMT1664M). The default is set to "0" (no Stacking Units

connected). If you wish to add Stacking Units, this number must be equal to the number of Stacking

Units connected. Press [ESC] to return to normal display.

Stacking Support

Unit(s): 0-3

6. Set LCD Contrast: Modifies contrast level of front panel LCD Display. Press the [ ] or [ ] button to

increase or decrease contrast, and press the [ESC] button to return to normal display.

Set LCD Contrast

Use Up/Down Keys

Note: LCD contrast can also be adjusted by holding the [

any time.