Electra WNG 25 DCI INV Service Manual page 63

3
INSTALLATION OF
THE INDOOR UNIT
Installation of the indoor unit only with one unit for
the sample.
INSTALLATION OF THE MOUNTING PLATE
Figure 6 shows the location of the mounting plate
relative to the unit size.
1. Locate the mounting plate on the wall in a horizontal
position.
2. Mark the position of the four mounting holes on the wall
and drill four holes to accommodate the dowels.
3. Mount the mounting plate on to the wall by the four
screws. Ensure screws are tightened properly.
30
167.5
8
93
Fig 6
U nit: mm
810
167.5
8
93
REFRIGERATION TUBE ROUTING
1.T here are five possible routes for installing the
refrigeration tube as shown in fig 7.
2.For route (6), cut the bottom notch in the rear.
3.For routes (4) or (7), cut the side notches in the rear and
in the front panel.
Fig.7
1.Front
2.Rear
3 .Righthand rear outlet
Fig 7
PENETRATION OF WALL FOR TUBING
1.Mark the location of the hole on either side of the
mounting plate as shown, in fig6 and drill it at a 5
downward angle, as shown in fig8.
2.T he hole is drilled at an angle, to prevent condensed or
rain water from penetrating back into the room.
3.Trim the hole in the wall with a
plastic tube.
Fig.8
A OUTDOOR SIDE .
B INDOOR SIDE .
Fig 8 1
APPENDIX A
4.Lefthand outlet
5.Lefthand rear outlet
6.Bottom outlet
7.Righthand outlet
4
70mm commercial
1. Drill 70mm
2. Wall
B A
O
5
2