Forced Disconnect Button (Emergency Supervisor Button) - iPECS -LIK Feature Description & Operation

iPECS-LIK
Feature Description & Operation Manual
2.86 FORCED DISCONNECT BUTTON (EMERGENCY
SUPERVISOR BUTTON)
Description
Each Digital station that have flexible button can make [FORCED DISCONNECT] button.
[PGM] + [Flex button] + [PGM] + [7#] + [HOLD/SAVE].
In PGM 109 – Flex23, New Numbering Plan – [Forced Seize Busy Stn/Co] is added.
By using this button in DKT or By using this Numbering Plan Code in SLT or DKT, busy co-line
can be seized forcedly, busy station can be intruded forcedly.
Operation
To activate forced co-line disconnect feature:
1. Seize CO line.
2. The user hears busy tone
A. In digital phone, press [Forced Disconnect] button.
B. In digital phone, press [TRANS/PGM] button, and dial [Forced Seize Busy
Stn/Co] numbering plan code.
C. In SLT, do hook flash and dial [Forced Seize Busy Stn/Co] numbering plan
code.
3. Busy line goes to idle state forcedly and the user hears a dial tone.
To activate forced intrusion to a busy station feature:
1. Call to busy station.
2. The user hears busy tone
A. In digital phone, press [Forced Disconnect] button.
B. In digital phone, press [TRANS/PGM] button, and dial [Forced Seize Busy
Stn/Co] numbering plan code.
C. In SLT, do hook flash and dial [Forced Seize Busy Stn/Co] numbering plan
code.
3. Busy station connected with the user forcedly.
Conditions
1. SLT user also can use this feature by dialing numbering plan.
2. If the station was talking to other station or CO line, the call is disconnected when
the station receives forced Intrusion call.
3. The busy station is connected to forced intrusion caller only after short indication
with beep tone.
4. Forced Intrusion call is not possible to a station in DND state.
5. Forced Intrusion call is not possible to attendant.
Programming
Related Features Hardware
251
Issue 6.0d1