iPECS -LIK Feature Description & Operation page 183

iPECS-LIK
Feature Description & Operation Manual
To abort SMDR printing
1. Press the [PGM] button.
2. Dial "0114", the SMDR abort code.
3. Press the [SAVE] button.
Conditions
1. For SMDR, if the first dialed digit(s) match the programmed LD code or the number
of dialed digits exceeds the LD digit count, the call is considered an LD call. When
behind a PBX, LD determination is made only if a PBX Trunk Access code is
dialed as the first digit(s).
2. Except for DISA calls, the duration of ring for an incoming call is provided in the
Dialed number field.
3. A header, including the assigned "Customer Site Id" is output after two blank lines
and is repeated every 66th line.
4. The SMDR output is a simple ASCII stream of up to 80 characters per line.
5. When enabled, SMDR call record timing begins after the "SMDR Start Timer"
expires and ends at call completion.
6. For security, if an Authorization code is entered as the Account code, the call record
will show "STA-P" and the station number, or "SYS-P" and the Authorization code
bin number in place of the Account code.
7. For incoming calls, the "NUM I" and "NUM II" fields will display the assigned data
item– Ring Service time, CLI, or CPN. For outgoing calls, the NUM I field will
always display the dialed number, user or system.
Programming
SYSTEM
Related Features

Call Cost Display

Lost Call Recording

Traffic Analysis

Authorization Codes (Password)
Hardware

RS-323 device to capture SMDR
1 SMDR Attributes (PGM 177)
2 Field I (PGM 177-Btn 20)
3 Field II (PGM 177-Btn 22)
4 Print Serial No (PGM 177-Btn 23)
5 SMDR DISC Cause (PGM 177-Btn 24-5)
6 SMDR ICM SAVE (PGM177-Btn 24-3)
7 SMDR ICM PRINT (PGM177-Btn 24-4)
170
Issue 6.0d1