Every 1000 Prints; Cleaning The Printhead - Magicard Tango 2e User Manual

RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL

Every 1000 Prints -

Step 2.
Changing the cleaning roller
There is a cleaning cassette inside the printer which holds a cleaning roller
recommend that this roller is replaced after every 1000 prints, or sooner if it looks dirty.
You re-use the cassette, and you replace
To replace the cleaning roller:
Switch off your printer.
•
Open the top cover. Locate the black cleaning cassette towards the rear of
•
the internal compartment.
To remove the cleaning cassette, hold it between thumb and forefinger by the
•
tab on the top of the cassette
lift it out.
You now have the cassette and roller assembly out of the printer. This is a two roller assembly.
•
The bottom roller is permanent and the top (larger) roller is disposable
Remove the used roller from the cassette
•
Take a new roller and remove the protective white cover from around the roller.
•
• Insert the new roller into the cassette, ensuring that the two small springs are above
the tacky roller, pushing it against the bottom roller.
back into the printer ensuring it is seated correctly.
• Insert the cassette
Step 3.

Cleaning the Printhead

You should clean the printhead if any lines are seen on printed cards.
To clean the printhead:
Use the special printhead cleaning pen from your Magicard printer cleaning kit. See 'Cleaning
•
Supplies'.
Open the printer and draw the pen several times across the length of the printhead.
•
the roller within it.
(picture 2). Push down lightly on it, and then
(picture 4).
Page 19 of 33
www.magicard.com
(picture 1). We
(picture 3).
1
2
3
4