Cleaning Supplies; Every 350 Prints Or Sooner - Magicard Tango 2e User Manual

RIO 2e, TANGO 2e & TANGO +L Printers USER MANUAL

Cleaning Supplies

Three cleaning cards and a cleaning roller are bundled with each new Rio 2 or Tango 2 printer. You can purchase additional cleaning
kits, which include cleaning cards, rollers and pens.
Cleaning Kits for Europe, Middle East, Africa & Asia
Part # M9005-761 - 10 cleaning cards, 5 rollers and a cleaning pen.
•
Cleaning Kits for North and South America
Part # N9005-761 Medium - 10 cleaning cards, 3 rollers, and 2 cleaning pens.
•
Part # N9005-761 Large - 20 cleaning cards, 6 rollers, and 3 cleaning pens.
•
Step 1.
Every 350 Prints or Sooner –
Using a cleaning card
We recommend that you clean your printer using a cleaning card after every 350 prints or each time you replace the dye-film.
You should do this more often if you print only a few cards a day.
To clean the card feed mechanism:
The printer must be switched ON.
•
Remove the card hopper and open the top door (the red light comes on).
•
Ensure the dye film is not touching the base of the printer inside. If it is, take up the slack by winding the supply spool backwards or
•
remove the dye film before starting the cleaning cycle.
Take a fresh cleaning card from its packaging.
•
Insert the narrow end into the card feed slot
•
Press the black button on the back of the printer (located above the USB connector). The card
•
is drawn into the printer (picture 2)
of the same card.
To ensure that the rear feed rollers located under the card hopper are
•
thoroughly cleaned, set the printer to its cleaning cycle, and instead of
inserting the card, simply hold it against these rollers
(picture 1).
and then ejected. Repeat this several times with both sides
(picture 3).
Page 18 of 33
www.magicard.com
1
3
2